SVR
Shock & Vibration Reducer
Shock and vibration reducer for the BHA. Wear-resistant composite sleeves stay stationary against the wall; the sub rotates inside.
Operating effect
75–80% torque reduction in the install zone. Cuts Stick-Slip and shock/vibration loads on the BHA.
Stationary composite sleeves
Wear-resistant composite sleeves are pressed against the wellbore wall and don't rotate. The non-magnetic steel sub rotates inside the sleeve — at the contact zone, friction shifts from steel-on-steel to steel-on-composite.
Vibration damping
Composite sleeves damp torsional, axial, and lateral shocks. They cut vibration transfer from the formation through the BHA up to surface equipment.
Non-magnetic steel
The sub body is non-magnetic steel — compatible with MWD/LWD. No magnetic distortion to inclinometer readings.
Sizes
| Parameter | SVR-120 | SVR-172 |
|---|---|---|
| OD across body, mm | 120.0 | 172.0 |
| Sleeve OD, mm | 142.9–152.4 | 209.6–215.9 |
| Sleeve length, mm | 500 | 500 |
| Sub length, mm | 1260 | 1260 |
| Sub material | Non-magnetic steel | Non-magnetic steel |
What SVR is used for
- 01
Lateral and torsional vibration damping in the BHA
- 02
MWD/LWD and RSS protection from vibration
- 03
Torque reduction in the installation zone
- 04
Longer bit and BHA component life
Run the numbers on your well
Send your well data and constraints — we'll run T&D modeling and come back with a configuration and the expected impact.